Witgain Technology Limited
People First Integrity Service
Add to Cart
Immersion Gold Half Hole PCB Board 50 Ohm 4 Layer 0.8MM
Board Info:
1 Part NO: Half hole PCB0016
2 Layer Count: 4 Layer PCB
3 Finished Board Thickness: 0.8 MM tolerance is +/-0.1MM
4 Solder Mask: Green
5 Min Lind Space&Width: 4/4 mil
6 Application Area: Blue-tooth Module
7 Drillings: L1-L4 0.2MM
8 BGA Size: 0.3MM
9 Surface Treatment: immersion gold
10 PCB Size: 102 mm* 97 mm/35pcs
11 Impedance control: 50 ohm
Our Product Categories:
1 FR4 substrate PCB : 2 Layer Printed Circuit Board, 4 Layer PCB, 6 Layer PCB, 8 Layer PCB, 10 Layer PCB, 12 Layer PCB, 14 Layer PCB, 16 Layer PCB, 18 Layer PCB, 20 Layer PCB, 22 Layer PCB, 24 Layer PCB, HDI PCB, High frequency PCB.
2 Aluminum Substrate pcb: 1 Layer Aluminum PCB, 2 Layer Aluminum PCB, 4 Layer Aluminum PCB.
3 Flexible PCB: 1 Layer FPC, 2 Layer FPC, 4 Layer FPC, 6 Layer FPC
4 Rigid-Flex PCB: 2 Layer Rigid-Flex PCB, 4 Layer Rigid-Flex PCB, 6 Layer Rigid-Flex pcb, 8 Layer Rigid-Flex PCB, 10 Layer Rigid-Flex pcb
5 Ceramic substrate pcb: single Layer Ceramic pcb, 2 layer ceramic pcb
FAQ:
Q1: What is Design Rule Checking (DRC) for PCBs?
A1: Design Rule Checking (DRC) is a process used to identify errors and mismatches such as spacing & trace widths in a PCB design/layout. The layout of a PCB board is designed using software, each PCB fabricator has a set of rules which they publish that specify various parameters such as what the spacing between each line should be, the minimum size of vias, the width of a line etc.
Once a design is submitted to a PCB Fabricator, they run a DRC test to ensure that the submitted design complies with their published standard. This ensures that the PCB will be fabricated to spec. If there are any mis-matches the DRC points them out and the designer then updates the design/layout accordingly. DRC (Design Rule Checking) is a must to ensure there are no design violations in the PCB. This check is done prior to the manufacturing of the final board.
The Design Rules are different for each PCB manufacturer. Users should check the design rules of a PCB fabricator before submitting a PCB Design to the manufacturer.